Home > Computer Won 39 T > System Does Not Boot?

System Does Not Boot?

Contents

OR follow the steps below. It can be that the pins are shorting each another and this is causing the system not to boot up even with the original memory cards. Recover the computer to original condition If the computer is not responding after you performed all of the other corrective actions in this document, you can restore the computer to its Your motherboard manufacturer's website will have a support page dedicated to your motherboard's model, and on this support page should be a compatibility list for such components as video cards, CPUs have a peek here

Report An eraser!!!!!! After having purchased a new motherboard and putting everything up, it did not work. Most likely it has to do with the screws and metal mounting stands (supports) that your motherboard sits on. No success.

Computer Not Powering On

Power cables not attached to graphics card. See the DO THIS FIRST - Perform a hard reset section for more information. Then turn it off immediately.

caution: Using a power adapter that does not meet the power requirements or has the wrong type of connector may damage the computer. in the end I have formatted the drive & installed vista again. I should mention my Windows 10 is not a technical preview and it is Windows 10 Home. Computer Has Power But Wont Turn On Otherwise, select the symptom below that best describes your issue and perform the troubleshooting steps provided.

I recently tried switching processors, Then when I downloaded a driver and restarted comp, it wouldnt boot, I switched back to my old processor and it didnt boot.. Computer Won't Boot Windows 7 Yes No Thanks for your feedback.Don't forget to take a few seconds to say thanks: Thank you Thanks for your feedback.We're sorry. Support Forum Join the conversation! http://www.howtogeek.com/173828/what-to-do-when-windows-wont-boot/ You'll have to rub the eraser on the gold plated part of the memory card (on both sides).

Turn on the computer and press f8 and then select Boot into Safe Mode. Computer Won't Boot Windows 10 After backup, perform a FULL FORMAT with the hard disk. Turn off your PC. If you can, try entering your BIOS settings menu as soon as your computer starts.

  • Co-authors: 30 Updated: Views:599,467 Quick Tips Related ArticlesHow to Fix Most Power Interruptions in a ComputerHow to Remove a Boot Sector VirusHow to Fix a 16 Bit Windows Subsystem Error (xp)How
  • Up next How to Repair a DEAD Computer - Duration: 37:05.
  • View article Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading...
  • Enter Your Email Here to Get Access for Free:

    Go check your email!
  • The specs of the machine are Made by Optima Computer, 384mb sdram (1X128mb+1X256mb), 1.6GHZ pentium 4 cpu, ASUS P4B-MX Motherboard.
  • I went and bought a new 1 gig memory for it (has four slots and can take 4 gigs total).
  • The section entitled Recover Files When Windows Won’t Boot gives excellent advice that is well within the scope of the article but I feel the advice to have a good backup

Computer Won't Boot Windows 7

I am not sure where to go from here. http://www.tomshardware.com/forum/297959-28-computer-starts-boot Flag as... Computer Not Powering On In the end it was a bad moterboard. Computer Won't Boot Up Black Screen Yes No Thanks for letting us know.

It had xp on but needed a password so I reformatted hdd and tried installing xp home but setup froze so I shut it off from the buton under the power http://placedroid.com/computer-won-39-t/system-wont-boot.html Then place it back into the memory slot. If your board has an extra 12v socket near the CPU, ensure the correct lead from the power supply is attached in addition to the large 24-pin ATX connector. Would really appreciate it. Pc Wont Boot To Bios

I can also run a disk called german police boot cd which loads fine & I get into the desktop only its XP pro on it. Everytime I plug the system or power it on, the green power light comes on in front and both the system and CPU fan run on high and nothing is displayed If you're "lucky", your computer will issue a series of beeps when it fails to turn on. Check This Out HP Customer Support Z7_3054ICK0KGTE30AQO5O3KA30U7 hp-contact-secondary-navigation-portlet Actions ${title} Loading...

Loading... My Computer Wont Turn On And Beeps Second, check the fuse in the plug. Symptom: Error message displays on a blue screen Symptom Possible Cause When you press the power button: LED lights glow, a fan spinning sound is heard, a text message displays on

The number of blinks or beep tones and their meaning is different for different computers.

In case you have overclocked, set your FSB and vCore down to stock levels. Tags: Desktop PCs, Laptops, Windows Share this article Share Tweet Send  Hi. This is located near the bottom of the motherboard. Laptop Not Booting I know the hard drive is working because I just took it out of another computer and it was working fine.

If a specific start up error message is displayed, search the following web sites for a specific solution: http://support.microsoft.com/ www.hp.com If you cannot search on a specific error message, perform one However, once it turned off, it will no longer turn on and boot up. If the LEDS do not glow and the fan or hard drive do not spin, the battery might need to be replaced. this contact form Answer this question Flag as...

HELP ME PLEASE Report tusri› DJ AKSHAY - Oct 1, 2009 at 05:09 AM Dear DJ AKSHAY, I am facing the same problem .My machine started freezing on desktop screen during I just couldn't believe it, but it solved all my problems. For more information, please see Overview of Recovering the OS or Reinstalling the Operating System. Report A.C.- Jul 3, 2009 at 10:20 PM Hey dj I tried all of those steps and I still have my problem do you have any other suggestions beside getting a

You should find the processor heating up. Thank you again for taking the time to help so many people. (lurkers included). If you can't do this from the boot menu, insert a Windows installation disc or recovery disk and use the startup repair tool from there. Aniruddha Dalvi 151,163 views 1:37 PC repair for DUMMIES - No signal to monitor - Duration: 9:06.

If you have one, the Windows DVD can be used, but otherwise you can download (using another computer – obviously) a rescue disc image and either burn it to a CD After the blink sequence is repeated, the LEDs do not glow until the power button is pressed again. Took out the memory sticks and no beeps. I'm going out of my mind here, 3 days ago, I restarted my PC and had all the wonderful symptoms of the other people in this forum, I researched all the

This is usually indicated by the lack of a beep and a failure message, or by a series of beeps to indicate an error code.[1] Operating System Not Found or BOOTMGR Now if you will excuse my absence I must be off to attend an askewed veil. While I have some pretty good and basic knowledge, based mostly on experience and learning from places like this site -- I certainly do not consider myself a geek by HTG If anything has come loose, there's a chance that it's disrupting the POST sequence.

When I finished, I powered up the PC, all I am seeing now is the manufacturer's logo. This means disconnecting your graphics card, additional drives, PCI expansion cards, and extra RAM. After the sequence of blinks or beeps, there is a pause for a few seconds, and the sequence of blinks or beeps is repeated (usually 3 times). The unit was working fine right before I decided to upgrade the memory ( was running very slow).

The computer model number is H2341. I have a feeling its the MB, as I've read some not so great reviews on the P5N MB's. Wayne Report kamleshdj› DJ AKSHAY - Jul 18, 2009 at 12:44 PM hey akshay,wats up??look I really nid ur help..i'm frm mauritius too.i am having the problem too also...pc boots,bu no It just beeped continuously.